I've got a Fan

Yes folks, hard to believe but I got it myself after a lot of hard work.






The fan is actually the heater fan removed from the MG with no little effort, lots of sweat and pondering and probably even more swearing.






For once I didn't read the the MG bible by Mr Porter. I read another publication I bought on E-Bay for a fiver. It's very good, don't get me wrong. But removing the heater is a dirty job so I popped indoors and got said book because its a little grimy ( For our colonial cousins read dirty)






Read instructions and away I went. Some inventive blows with the hammer onto the large screwdriver in turn resting on Phillips screws very rusty, managed to free them without loss or damage. Removed two hoses connected to front of heater, easy peasy.

Should be free to be lifted up and forward, perhaps with some gentle persuasion.

Grrr......


puff.......


pant......


ouch !..( screwdriver slipped)


wrestle...


rock........


Time for a re-think. The bloody little thing would not budge.


Looked under dashboard to see if any pipes are connected......No, not much is actually connected dash-wise anyway after its removal and a few heater pipes last year.


Pokes around into where base of heater feeds to....nothing.


Back to wrestling then, but re-positioned to LH side of car.


Slowly some movement but then static and unmovable.


Grrrrr


Reads book again


Wrestles again.............more Grrr


Looks at mess under dashboard again.


Re-reads book......................................Ooooops "REMEMBER TO DISCONNECT THE HEATER CONTROL WIRE AT THE DASHBOARD CONTROL LEVER"


Yes it said it there right in the first paragraph. How can you not understand that !!! doh!!


So here is a picture to prove it.

There on the transmission top was a rather rusty and forlorn device dangling like an ignored heater control lever. Two small nuts undone and away it came from the brake cable type wire and sheath. Round to the heater box, a few wiggles and plop. Out it came.

Well bugger me, it was the wire holding it in all the time. Don't let that fool you though.

Apparently they are quite difficult to remove, and even harder to put back with nice new fat and not very spongy foam seals. The heater don't look too bad. It would never have worked though. The large flap at the base of the fan, which directs air down to the four internal pipes/vents was rusted shut and stuck with manky foam. The bracket that the wire attaches to on the flap had also parted company with the flap so not all was in vain. The rest of the heater looks in good nick. It just needs a good clean and new seals/foams. The wonderful MGOC offers uprated heater matrix and larger fan as the heater on the MG is not the best. In fact our American friends think its the heater from hell. Hey-ho, you have global warming now.

I'm tough though and can stand a little cool air in winter. ...................Ha. Not true. I cant afford or won't spend the money, on what I see as a pretty pointless mod.

Here is a view of the base of the heater box.

Great Innit !

Next few week should see some major strides in bodywork additions. Wifeys allowing me loadsOmoney to spend as a birthday prezzie. New L front wing base repair section, new L rear wing complete, repair panels for inner outer wing. Hope it don't rain then as we've not seen any for a few weeks..yippeeeee.

Sods law though. I've got no money so not much work has been done.

I'll be 50 next post.................almost one of Wogans T.O.G's

see you all soon