When tools have "Off Days"

Some time after welding on the rear wing, or was it just before, I had a real bad tool day.

Same as the wife's bad hair days, only worse.

I had to cut out several small rectangular pieces using the trusty jigsaw. The jigsaw has served me well over the years and has cut lots of things. I had "modified" it to get at awkward parts on the MG, by removing the base, and somehow never got it to go back together exactly right.

On the day in question I did manage to get it back as it should be and proceeded to make an extra long cut in a removed doorskin. See.......I'm even managing to make it a green car by recycling as much good steel as possible. But I'm afraid it just died. Even after suspecting all that was wrong was the brushes, no, it had run its joyful and varied life. The rotor/commutator windings had just disintegrated, poor old B&D jigsaw.

Still all was not lost, I just did it the old fashioned way with hacksaw and effort. God I missed the jigsaw. So then to welding, after 1 minute of expert welds, spit, spatter, silence.

The welding wire had all been used up !. God when I bought the welder it had about 37 miles of wire on the spool. So 4 CO2 bottles later it had eventually gone. What to do on a sunday afternoon with intermittent fine drizzle and sunny spells ? More grinding, thats what I'll do.

The grinder had allready had new carbon brushes fitted a few months ago, Ten Bloody pound 99p, when the whole grinder cost only £ 14.99..........Scre**ix are not my favourite people.

But no, it coughed and spluttered,I shook it, I banged the brush mounts with relied upon persuading tool ( Hammer) but nuffin. Inspecting the brushes showed thet were not quite worn down but the copper wire connecting them had parted company with the carbon, Both sides !!!

Then, whilst cleaning up and "reshaping" the battery box cover the workmate jaws just gave up and turned from two just functioning ( they have been out in the rain for the last two years)

parts into four non functioning parts !!!!!!!!!

So there I was, well and truly Scr#*(ed/f!xed). Thats when I hatched a plan to start on the engine.

Well after all it was all cluttering up the shed methinks.

So the bodywork and tools could wait till the cash was plentiful, all I need do is find the engine parts,clean& inspect and re-fitt............................hahahahaaaaaaaaaaaaaaa

oh, and try to make new workmate jaws.........this is an easy job,....... innit ?????

Next Instalment................................................... How to hide a cylinder head and many auxillary engine parts in an average 3 bed semi ( with shed at bottom of garden)