spring thing and more work

Well, the front suspension is finally finished, discs purchased and fitted and the car lowered to the ground at long last.
The fitting of the disc was easier than I thought. I did have reservations regarding the hub to disc bolts. They were a swine to remove. I had to drill the bolts out since the back face did not allow for a spanner or my socket access. In the end I found a long forgotten box spanner of 14 mm that did the job just fine with accompanying 1/2" socket.
Also the oil seal to hub was tricky to remove but replaced with a brand new pair, using a nice new flat section of 1" x 3"x 6" timber, liberal grease and lump hammer.

The only blot on the landscape was the final ride height. It looks too high, even thought I've replaced the spring with one over 1-1/2" shorter.
Also, since the two wheels/tyres had been used as makeweights for the car cover, when fitted and lowered back to earth one was flat as a fart.
That's when the faffing started.
I visited three filling stations ( all with the same type of inflator) only to find out the business end of the inflator does not fit my valve. Strange that, since I've inflated them before ( albeit years ago) and did not have an Issue.
The economy run continues so I've decided to replace only one brake cylinder but both side's caliper seals in full, re-use the existing hoses and buy standard pads,clips and re-use the rear brake shoes.
I've even fitted the bump strap bolts since I can now jack up the rear end.

Son also helped me push the car to turn it round on the drive ( again).
After inspecting the RH rear hub/back plate I discovered the back plate was slightly oily/cruddy and some slight play in the drive/hub/spline. I'll do what I normally do for this rather expensive repair, Ignore it for now. At the least it is just pinion crown wheel spacer wear and worse half shaft spline wear with weeping oil seal. Thank god for the wonderful John Twist of University motors. I urge you all to visit youtube to see his wisdom and  educational dedication to the marque for would be restorers.

So next on the list is more sanding (wether [ and weather] permitting) since I should buy the caliper and pads plus fluid ,but that looks like its going to be a Christmas present  due to some ongoing financial embarrassment ( No job as of yet).

Above  is the RH hub. Sorry as it a little blurred ( I was cold, wet and fed up )